Double-end-trimmer-and-boring-machine Operator
Overall rating: (N/A)
|
Sets up and operates multiple-spindle boring and trimming
machine to bore vertical or horizontal holes and trim or miter
ends of stock used in furniture manufacturing: Reads work
specifications to determine location, angles, depth, diameter,
and number of holes to bore in stock and cuts to be made by
saws.
Installs specified bits in spindle chucks, using wrench.
Adjusts chucks for location specified, using handtools and
pattern stock. Attaches holders, jigs, or stops, and adjusts
pneumatic clamps with handtools. Removes pattern and starts
boring heads and saws. Positions stock under clamps and against
stops on machine bed, and depresses pedal or turns automatic
cycle lever to activate machine to clamp, bore, trim, and
release stock. Periodically verifies accuracy of setup by
comparing trimmed and bored stcok with pattern stock, using
caliper, square, or tape measure.
May opearte machine that trims
or miters only one end of wooden stock and be designated
Single-End-Trimming-And-Boring-Machine Operator (woodworking).
|
Write a comment about the job
Double-End-Trimmer-And-Boring-Machine Operator
|
